Leaser Cutter

Make a stand to stand the Nintendo switch with a 3D printer

On the back of the Nintendo Switch, there is a small stand that allows you to stand the switch up and play with it. Howe...

2021.04.07

Rose

3D PrinterElectronicsLeaser Cutter

I wanted to make a plane luminescent light. This is the same mechanism used in the backlighting of laptop computers, whe...

2021.04.07

Rose

ElectronicsLeaser Cutter

If your mailbox is outdoors, you will not know if your mail has been delivered. Often, we don't even notice for a while ...

2021.03.21

Rose

ElectronicsInstruction ManualLeaser Cutter

When you use a laser cutter to make a stamp, you usually use silicone rubber.This time I would like to make a stamp by c...

2021.02.06

Rose

Leaser Cutter

I made a key chain from MDF and veneer, engraved & cut with EtcherLaserPro.Preparing the processing dataFirst, convert m...

2021.01.10

Rose

ElectronicsLeaser Cutter

EnclosureThe enclosure is the box that the speaker is in, the speaker box.Since I bought a speaker before, I would like ...

2021.01.01

Rose

ElectronicsLeaser Cutter

In this article, I would like to investigate the parameters (conditions) for cutting veneer boards with EtcherLaserPro.W...

2021.01.01

Rose

ElectronicsLeaser Cutter

This is a summary of the parameters (conditional settings) for cutting MDF board with EtcherLaserPro, based on actual cu...

2021.01.01

Rose

ElectronicsLeaser Cutter

The EtcherLaserPro that I had ordered has arrived. I set it up and did some test cutting, so here is how I set it up and...

2021.01.01

Rose

ElectronicsLeaser Cutter